1. The width of the cargo fork
The width of the fork is determined by the size of the pallet in daily use. The standard size of the general manual hydraulic car is divided into wide car and narrow car, wider size 685*1220mm, narrow size 550*1150mm.
2. Load capacity
Generally speaking, the international standard has 2.0T- 2.5T -3.0T-5.0T, these four kinds of load weight.
3. Lifting height of cargo fork
Standard pallet height is generally 100mm, so the minimum height of manual hydraulic truck is of course under this. General hydraulic truck to the lowest point when the height is 85mm, 75mm two kinds, of course, there are special low type manual hydraulic truck, the lowest height can even reach 35mm.
The general price of lower height is a little expensive, no special demand is not recommended to purchase. In addition, the steel plate of the low height 35mm manual truck is relatively thin, so the maximum load is only 1.5 tons.
Manual hydraulic pallet truck
4.Fork steel plate thickness
Generally, a better 3.0Ton pallet truck uses 4mm steel plate, for inferior quality, the thickness of the steel plate and the thickness of the paint can not reach 4mm, and some can even only reach 3mm. So the price advantage in exchange for bad material is not responsible for consumers. Such hand pallet jack are prone to failure in subsequent use.
In addition, the steel plate thickness of the standard 5.0Ton manual hydraulic pallet jack should also reach more than 8mm, otherwise it is difficult to bear such a heavy weight.
5. Wheel materials
Manual hydraulic wheel materials should be selected according to the conditions of the working ground. If the ground is smooth, you can choose nylon wheels, because nylon wheels are relatively cheaper and less effort to pull. The ground condition is not good, you can choose aluminum alloy plus PU wheels, they are more wear-resistant. If you do not want to hurt the ground too much, such as some factory floor ground, it is best not to use nylon wheels, should choose polyurethane wheels. Because nylon is so hard, Polyurethane wheels are relatively soft.
Post time: Nov-16-2022